Replace worn or mismatched fasteners with a factory-correct 20-piece set of genuine Mazda RX8 wheel nuts.
$120
RX8 wheel nuts sourced directly from Mazda replace corroded, damaged or mismatched wheel fasteners with a complete, factory-correct set. This 20-piece genuine set covers all four wheels on both Series 1 and Series 2 cars. Every nut is new, so there is no uncertainty about thread condition or previous use. Genuine Mazda hardware brings correct specification from the factory, not a close-enough aftermarket substitute.
For rotary enthusiasts, swapping the complete set of RX8 wheel nuts at once removes the visual inconsistency of mixed hardware. It also eliminates any doubt about torque retention on fasteners with unknown service history. Whether completing a wheel swap, a tyre change, or a broader exterior refresh, these genuine Mazda wheel nuts give every corner the same new, factory-spec hardware.
Combine this set with the GENUINE MAZDA OEM Rear Boot Brake Lamp Cover for a tidy genuine-parts exterior refresh. The HASEPRO Magical Art Revival Pre-Cut Headlight Protection and Restoration Film completes the look by restoring clarity to ageing headlight lenses. For official Mazda brand and parts information, visit Mazda Australia.
| RX8 Model |
|---|
Related RX8 Upgrades
Yes, the genuine Mazda wheel nut set fits both Series 1 (2003-2008) and Series 2 (2009-2012) RX8 models. The M12 x 1.5 thread specification matches the wheel hardware requirements across the full production run.
The RX8 wheel nuts use an M12 x 1.5 thread, which is the correct factory specification for Mazda RX8 wheels across Series 1 and Series 2 models.
The set includes 20 wheel nuts, which is enough to replace all fasteners across all four wheels at once and ensures every wheel gets matching, new-condition hardware.
Replacing the full set eliminates mismatched hardware around the car, whether from corrosion, previous owner substitutions, or mix-and-match replacements over the years. A complete 20-piece set restores a consistent factory appearance and removes the uncertainty that comes with retaining fasteners of unknown age or condition.
Yes, these are genuine Mazda OEM parts, not aftermarket substitutes. They are factory-correct in thread specification and finish, so they seat and present exactly as the originals did when the car was new.
That depends on your aftermarket wheels. The nuts are M12 x 1.5, which is a common fitment, but you should confirm your aftermarket wheels require the same thread pitch, seat type, and nut dimensions before fitting. These are designed and verified for Mazda RX8 OEM wheel fitment.
As genuine Mazda parts, they are made to the same standard as the originals fitted at the factory. Starting with new-condition hardware means you are not inheriting the corrosion, thread wear, or surface damage that can accumulate on used or aged fasteners.
